In the previous chapter, the editor mainly listed the common manifestations of faults in the mud pump of the sprayer. In the following article, the editor will answer questions and provide targeted solutions for slope greening equipment manufacturers to solve the problems that occurred in the mud pump of the sprayer in the previous article.

Tip 1: Solve the problem of not being able to suck on its own

a. The mud pump body of the sprayer is not filled with storage fluid or the storage fluid is insufficient, but sufficient storage fluid is added;

b. Leakage in the suction pipeline of the mud pump of the sprayer, check and eliminate the leakage phenomenon;

c. The mud pump speed of the sprayer is too low, adjust the sprayer speed;

d. The suction stroke of the mud pump of the sprayer is too high or the suction pipeline is blocked, reducing the suction stroke or shortening the suction pipeline;

e. Impeller flow channel or suction pipeline blockage, eliminate pipeline blockage

Tip 2: Insufficient stress relief

a. The impeller or impeller sealing ring is severely worn, replace the mouth ring;

b. Insufficient power and low speed, adjust to speed by adding full horsepower;

c. The import or export valve is not fully opened, fully open the import or export valve.

Tip 3: Solve the problem of excessive consumption

a. Excessive traffic, reduce traffic; The speed is too high, reduce it appropriately;

b. Correction or replacement of pump shaft distortion or impeller jamming;

c. The flow channel inside the pump is blocked or stuck, eliminate the blockage

d. The noise and vibration of the mud pump in the sprayer are relatively high;

e. Unstable footing, reinforce;

f. Cavitation phenomenon, adjust working conditions;

g. The bearing is severely worn and needs to be replaced with a new one;

Tip 4: Solve the problem of loud noise and vibration

a. The flow channel inside the sprinkler pump of the sprayer is blocked or stuck, correct or replace it;

b. If there are debris in the sprinkler pump or inlet pipeline of the sprayer, remove the debris;

c. The main axes of the sprinkler pump and the power machine are different, adjust the coaxiality;

Looking at the small tricks listed by the manufacturer of slope greening equipment for solving the problem of mud pump failure in the sprayer, do you feel like the whole world is beautiful in an instant? I sincerely hope that the tips summarized by the editor can be helpful in solving the problem of the mud pump in the sprayer. I have listed them one by one, and I hope that my efforts can be shared to a great extent.